Date of Publication :14th March 2018
Abstract: A cross stream miniaturized scale heat exchanger was intended to augment heat move from a fluid water-glycol to a gas or air for a given frontal territory while holding pressure drop over the warmth exchanger of every liquid to values normal for customary scale heat exchangers. The expected performance of these micro heat exchangers for ceramic, plastic and aluminium is compared with each other and with existing revolutionary car radiators. Forced convection together with increased dissipation radiator form is used to improve heat dissipation from the electronic components. Using the field of integrated microsensors and micro-actuators, called MEMS, provides us with a significant link between microelectronics and non-electronics applications and a power method enabling these heat exchanger devices to be implemented. A micro heat exchanger is designed to be made of a non-uniform series of silicon micro pins. Finite Element Modelling (FEW) is used to simulate pin size and shape based on two separate convection models. Three micro-heat exchangers are designed and tested based on the conventional heat transfer enhancement principles for use in a liquid cooling system with a long offset strip, short offset strip, and chevron flow line. The thermal efficiency of the offset strip heat exchangers is higher than the straight channel heat exchanger. The heat exchanger's output with the shorter strip is higher than that of the longer strip heat exchanger.
Reference :
-
- A. G. McDonald and H. L. Magande, “Fundamentals of Heat Exchanger Design,” in Introduction to Thermo-Fluids Systems Design, 2012.
- K. Thulukkanam, Heat Exchanger Design Handbook. 2013.
- R. K. Shah and D. P. Sekuli, Fundamentals of Heat Exchanger Design. 2003. [4] D. P. Sekulic, “Compact heat exchangers,” in Handbook of Thermal Science and Engineering, 2018.
- F. A. S. Mota, E. P. Carvalho, and M. A. S. S. Ravagnani, “Modeling and Design of Plate Heat Exchanger,” in Heat Transfer Studies and Applications, 2015.
- C. Knellwolf, H. Peron, and L. Laloui, “Geotechnical Analysis of Heat Exchanger Piles,” J. Geotech. Geoenvironmental Eng., 2011, doi: 10.1061/(ASCE)GT.1943- 5606.0000513.
- M. A. Arie, A. H. Shooshtari, S. V. Dessiatoun, E. Al-Hajri, and M. M. Ohadi, “Numerical modeling and thermal optimization of a singlephase flow manifold-microchannel plate heat exchanger,” Int. J. Heat Mass Transf., 2015, doi: 10.1016/j.ijheatmasstransfer.2014.10.022
- T. Gundersen, “Heat Integration: Targets and Heat Exchanger Network Design,” in Handbook of Process Integration (PI): Minimisation of Energy and Water Use, Waste and Emissions, 2013.